1、昆明防水http://kmfangshui.hbugo.com/分析由于排水管高度不够高，大便器出口插入排水管的深度不够，连接出没有填抹密实，卫生间内防水处理不好，大便器使用后，就会出现地面积水，墙壁潮湿，甚至下层顶板墙壁也出现潮湿和滴水现象。
Jinan water analysis due to the height of the drain is not high enough, toilet drain outlet insert deep enough, do not fill out wiping dense connections within the toilet water is not properly handled, after toilet use, there will be ground water, damp walls, and even the lower roof and dripping wet walls also appear phenomenon.
2、昆明防水介绍施工时蹲坑上水接口处被砸坏而未被发现，上水胶皮碗绑扎不老或用铁丝绑扎后，铁丝锈蚀断坏，以及胶皮碗与蹲坑上水连接处破裂，会使蹲坑在使用后出现地面积水，墙面潮湿，造成下层顶板和墙壁也有潮湿和滴水现象。
Jinan waterproof construction pit when introduced at the interface were smashed in Sheung Shui and undetected, Sheung Shui or not the old rubber bowl with wire lashing after lashing, wire rust off the bad, and the rubber bowl and break the connection pit Sheung Shui, will pit appeared after using ground water, damp walls, causing the lower roof and the walls are damp and dripping phenomenon.
3、昆明防水谈到下水口表高于地面或卫生间设备标高不适应，形成倒泛水，楼板套管上口高出地面高度过小，水直接从套管渗漏到下层顶板。
Jinan water table comes to drain or toilet facilities above ground level suited to form inverted pan of water, catchy casing above the ground floor height is too small, the water leakage from the casing to the lower roof.
4、昆明防水http://kmfangshui.hbugo.com/提醒穿楼板管道未作套管、凿洞后昆明未处理好混凝土内有转、木屑等杂物，是堵洞混凝土与楼板连接处产生裂缝，造成防水层与找平层粘结不牢，形成进水口，水通过缺陷部位进入结构层，使顶板出现渗漏。
Jinan waterproof floor pipes have not been reminded to wear sleeves, a hole after hole good and turn untreated sawdust and other debris in concrete, is plugging the hole with concrete floor joints crack, causing the waterproof layer and the leveling layer bond is not strong, forming inlet, water enters through the defect site structure layer, so that the roof leakage.