1、济南专业防水http://jnfangshui.hbugo.com/谈到应采用针穿刺法每100平米刺三个点，用尺测量其高度，取其平均值，成膜厚度应大于2毫米，穿刺时应用彩笔做标记、以便修补。
Jinan professional waterproof talked needle method should be used to stab three points per 100 square meters, with a ruler to measure the height, the mean value, film thickness greater than 2 mm, use crayons puncture mark for repair.
2、在济南专业防水施工中，监理人员可到施工现场将搅拌好的料，分多次涂刷在平整的玻璃板上，成膜厚度1.2－1.5毫米，放置7天后，在1％的碱水中浸泡7天，然后在50土 2烘箱中烘24小时，做哑铃型拉伸实验，要求延伸保持率达到80％（无处理为 200％）。如达不到标准，说明在施工中乳液掺加比例不足。
Jinan professional waterproof construction, construction site supervisors can to the stirred materials, in multiple brushing on a flat glass plate, a film thickness of 1.2-1.5 mm, for 7 days, soaked in 1% of alkaline water 7 days, then bake at 50 earth 2 oven for 24 hours, do dumbbped tensile test, it requires extending retention rate of 80% (no treatment is 200%). Not up to standard as described in the construction of the emulsion adding unresented.
3、济南专业防水介绍将涂料分多次涂刷在水泥块上，成膜厚度1.2－1.5毫米，放置7天，放入1％碱水中浸泡7天，不分层，不空鼓为合格。
Jinan professional waterproof describes the coating in multiple brushing the concrete blocks, a film thickness of 1.2-1.5 mm, for 7 days, add 1% alkaline soak seven days, not hierarchical, not hollowing qualified.
4、济南专业防水http://jnfangshui.hbugo.com/建议在有条件下，应用仪器检测，其方法是将涂料按比例配好，分多次涂刷在玻璃板上（玻璃板先打蜡），厚度为 1.5毫米，静放7天，然后放人烘箱内50±2烘24小时，取出后放置3小时，做不透水实验，不透水性为0.3MPa，保持30分钟无渗漏为合格。
Jinan professional waterproof conditionally recommended application equipment testing, the method is to paint with a good pro rata, in multiple brushing on the glass (glass before waxing) and a thickness of 1.5 mm, quiet place seven
days, then to release the oven 50 ± 2 bake 24 hours, place three hours after the removal, do impervious experiments, impermeability to 0.3MPa, for 30 minutes without leakage in compliance.